Materials
Gather these supplies
- Clean 2-inch PVC offcuts
- 36-inch 1×6 backing board
- Pipe straps
- Structural wall screws
- Bottom stop cleat
Free step-by-step project guide
Build a PVC-Sleeve Tool-Handle Rack
Short vertical sleeves on a strong backing that keep rakes, shovels and brooms upright.
What you are making
A useful project with a defined stopping point.
Mount smooth pipe sections to a structural wood panel so handles cannot fall into a walkway.
- Time
- 1–2 hours
- Difficulty
- Moderate
- Estimated cost
- $15–$45
- Finished size
- 36-inch backing with 5–6 sleeves
Tools
Set up the work area
- Stud finder
- Saw or PVC cutter
- Drill/driver
- Level
- Deburring tool
- Eye protection
Measurements
Mark before cutting
- Sleeves: 8–10 inches long
- Spacing: 5–6 inches on center
- Bottom stop: 4 inches above floor
- Mounting: into at least two studs
Build it in order
Step-by-step instructions
Read the entire plan before making the first cut or hole. The check under each step tells you when it is ready to move forward.
- 01
Lay out the tools
Place tools on the floor and measure handle and head clearance.
- 02
Cut and smooth sleeves
Cut equal pipe pieces and round both ends completely.
- 03
Mark the backing
Space sleeves on the board and mark two straps per sleeve.
- 04
Attach sleeves
Fasten pipe straps snugly and add a bottom cleat or cap where handles need support.
- 05
Mount to framing
Level the board and screw through it into at least two wall studs.
- 06
Load and label
Insert tools handle-first, keep blades low and inward, and label each position.
Use and maintenance
Keep it useful
- Clean soil from handles before storage.
- Keep frequently used tools at the ends.
- Retighten straps when PVC changes with heat.
Safety boundaries
Know when to stop
- Mount only to structural framing.
- Guard sharp blades.
- Keep heavy tools below shoulder height.
Build alongside our family
See the projects and systems behind the ranch.
These written plans give you the order and measurements. Our YouTube videos show the ordinary problem-solving, repairs and family work that inspired this library.
Use the rest of the material
More leftover pvc guides
Easy · 1–2 hoursBuild a Lightweight PVC Garden Trellis
Easy · 30–60 minutesMake Smooth Hose-Guide StakesReused materials and sites vary. Inspect every material, follow the manufacturer’s tool instructions and use appropriate protective equipment. Stop and ask a qualified person when structural loads, electrical work, pressurized plumbing, drinking water, hazardous coatings, animal security or local requirements exceed your experience.